Downloads
 |
TMS Data SheetThe datasheet fully describes all aspects of TMS not covered in other documents |
|
|
TMS Receiver Application & Test GuideTMS Receiver Application and Test Guide for help with antenna positioning and system testing |
|
|
Fact Sheet
|
|
|
Product Brochure
|
|
|
TMS2 Mounted Using Patch
|
 |
TMS Manager.exe (240KB)TMS Manager PC application allows you to set up and use the TMS receiver and TMS operator interface. |
 |
MMapV5.exe (152KB)MMapV5.exe loads the Memory Map firmware, which works with TMS Manager. All receivers are shipped with the Memory Map interface loaded. For further information see the datasheet. |
|
|
TMS_AS_V1.exe (156KB)TMS_AS_V1.exe loads the ASCII Stream firmware. This interface does not work with TMS Manager, it often used to interface third party equipment. For further information see the datasheet. |
|
|
TMS27V5.exe (176KB)TMS27V5.exe upgraded TMS27, the Operator interface to version 5, which is its latest firmware. This is necessary if you wish to run the latest version of TMS Manager, but your are running version 4 or previous. Click About on TMS Manager to see your version. Please note: we have now adopted conventional wheel numbering (clockwise from the front-left), so after upgrading from previous versions please check your wheel configuration. |
Updating Firmware
Run a firmware update .exe file if you need to upgrade your Receiver or Operator Interface.
To change between interfaces:
- Run one of the .exe files.
- Select the COM port to which you have connected the receiver unit.
- Power the unit off then on.
- It should take a few of seconds to program and you should see the message "Programming Succeeded".
GET IN TOUCH