Downloads

TMS Manager.exe (240KB) version 9

TMS Manager PC application allows you to set up and use the TMS receiver and TMS operator interface.
TMSLogGraphV1_setup.exe(1.3MB) version 1

A tool to create graphs of and visualise TMS data logs.
MMapV6.exe (156KB)

MMapV6.exe loads the Memory Map firmware, which works with TMS Manager. All receivers are shipped with the Memory Map interface loaded. For further information see the datasheet.
TMS_AS_V1.exe (156KB)

TMS_AS_V1.exe loads the ASCII Stream firmware. This interface does not work with TMS Manager, it often used to interface third party equipment. For further information see the datasheet.
TMS27V7.exe (180KB)

TMS27V7.exe upgrades TMS27, the Operator interface to version 7, which is its latest firmware.

Version compatibility: You are advised to upgrade to the latest version of TMS Manager when upgrading your TMS27. We now offer more wheel numbering options which are not supported by older versions of TMS Manager.

Connect a serial lead from your computer directly to the unit you are programming.
Run a firmware update .exe file if you need to upgrade your Receiver or TMS27.
Select the COM port to which you have connected your serial lead.
Power the unit off then on.
After a few of seconds to program and you should see the message "Programming Succeeded".

Fact Sheet